Page1
Home ] [ Page1 ] Page2 ] Page3 ] Page4 ] Page5 ] Page6 ] Page7 ] Page8 ] Page9 ] Page10 ] Page11 ] Page12 ] Page13 ] Page14 ] Page15 ] Page16 ]

 

CA101 SWING-IN-KEEPER
Use for retaining 16 SWG. push-rods to rudders, control horns, servos, car steering, etc. Length 14mm.
CA102 MINI SNAP LINK
For connecting push-rods to control horns, servos, rudders etc. combines with 2mm. threaded rod CA127 and with metal extenders CA123 to make them adjustable. Length 21mm.

CA103 MINI SNAP LINK complete with 8"adjustable connecting rod.

CA104 BALL LINK CONNECTOR / BALL / NUTS
Ideal for different connections, throttle, glider rudders, car steering joints etc. Can be used with CA123 to give adjustment. Length of connector approx. 21mm.

CA105 BALL LINK CONNECTOR / BALL / NUTS with 8" rod.
As CA104 threaded rod enables adjustment.

CA106 SPARE NYLON CONNECTOR FOR BALL LINK
CA107 NIPPLE LINK
Very popular link using a solderless nipple that can be used on piano wire, bowden cable and plastic rod, instantly adjustable by slackening screw and sliding along. Length 25mm.
Applications include: Throttle connections.

CA108 SMALL CONTROL HORN with screws & nuts.
For rudder, elevator, aileron control etc. Screw size: 10ba. x 3/4."

CA108A SMALL CONTROL HORN
As above but without fixing screws. Height approx. 22mm.

CA109 LARGE CONTROL HORN with screws & nuts.
Use as CA108 but additional height reduces surface movement.

CAl09A LARGE CONTROL HORN
As above but without fixing screws. Height approx.30mm.

CA110 90° BELL-CRANK with screws & nuts.
Used for transferring linkage through 90° e.g. inset ailerons, boat throttles etc.

CA110A BELL CRANK
As above but without screws and nuts, length of arms from fulcrum: 26mm. approx.